Figure 71. Installing optional IDSDM module
Next steps
1.
.
NOTE:
Reinstall the MicroSD cards into the same slots based on the labels you had marked on the cards during
removal.
2. Follow the procedure listed in
After working inside your system
Optional IDSDM or vFlash module
NOTE:
The write-protect switch is on the IDSDM or vFlash module.
Removing the MicroSD card
Prerequisites
1. Follow the safety guidelines listed in
on page 71.
2. Follow the procedure listed in
Before working inside your system
Steps
1. Locate the MicroSD card slot on the vFlash/IDSDM module, and press the card to partially release it from the slot. To locate IDSDM/
vFlash module, see the System board jumpers and connectors section.
2. Hold the MicroSD card and remove it from the slot.
NOTE:
Temporarily label each MicroSD card with its corresponding slot number after removal.
126
Installing and removing system components
