Dell Networking W-7010, Руководство по установке

Страница: 20 / 28

20 | Installation Dell Networking W-7010 Controller | Installation Guide
Table or Shelf Installation
Required Tools and Equipment

Rubber Feet
Installation Steps
1. Attach the rubber feet to the bottom of the controller (see Figure 9 ).
Figure 9
Attaching Rubber Feet
2. Place the controller on the desired flat table or shelf.
Wall Mounting
The mounting brackets can also be used for wall mounting the W-7010 controller.
Required Tools and Equipment
The following tools and equipment are required for installing an W-7010 controller on a wall:

Mounting Brackets (x2)

Screws for the mounting bracket (x8): M4 x 8 mm Phillips Flat Head Screws

Wall Anchors: Optional accessory (not included in the package)

Wall Mounting Screws: The type of screw depends on the installation surface (not included in the package)

Suitable Screwdrivers for all screw types (not included in the package)
Installation Steps
To install a W-7010 controller on a wall:
1. Fasten the mounting brackets over the mounting holes on the sides of the W-7010 controller using the eight
screws for the mounting brackets (four per bracket) and a suitable screwdriver (see Figure 10 ).
NOTE: Ensure that the Ethernet ports are facing down when installing the W-7010 controller on a wall.