Dell EMC VMAX3, Руководство по планировке объекта

Страница: 92 / 100

Procedure A, Task 2: Dell EMC Customer Engineer
Before you begin
Before connecting power to the system, make sure that the power for both zone A and zone B are
turned OFF. This task is performed by the Dell EMC Customer Engineer.
Figure 34 System bay power tee breakers (OFF = pulled out)
2
1
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
PDU PDU
System Bay (rear view)
Zone B
Zone A
1
2
3
4
5
6
1
2
3
4
5
6
Power zone B
Left side
Power zone A
Right side
1
2
3
4
5
6
1
2
3
4
5
6
Zone A
Right side
Zone B
Left side
Power zone B
Left side Power zone A
Right side
(With rear door remo
ved)
(With rear door )
ON
OFF
1
2
3
4
5
6
1
2
3
4
5
6
Procedure
1. Confirm that the customer-supplied power cables are labeled and that each label contains
the relevant customer-supplied PDU and circuit breaker numbers. If power cables are not
equipped with labels, alert the customer.
2. Compare the numbers on the customer-supplied power cables for each Dell EMC bay to
verify that power zone A and power zone B are powered by a different customer-supplied
PDU.
3. Do one of the following to connect power zone A and power zone B in each bay. If
necessary, use the 15ft extension cords provided by Dell EMC.
l
For single-phase power: Connect customer-supplied PDU power cables to the Dell EMC
bay by connecting to the bay's AC input cables for power zone A and power zone B as
shown below.
Best Practices for AC Power Connections
92 Dell EMC
™
VMAX3
™
Family Site Planning Guide VMAX 100K, VMAX 200K, and VMAX 400K