5
On the
Work
window, select the
General
tab.
6
From the
Timezone
drop-down list, select the time zone you want to use for the Cisco UCS
instance.
7
Click
Save Changes
.
Adding an NTP server
Cisco UCS requires both an instance-specific time zone setting and an NTP server to ensure the correct
time appears in the Cisco UCS Manager. When you add an NTP server, devices receive time from the
same source.
About this task
Set all devices in a Converged System to the same time.
Before you begin
Set up the NTP server to be reachable using an IP address from the Cisco UCS Manager.
Procedure
1
Log on to the Cisco UCS Manager.
2
On the
Navigation
, select the
Admin
tab.
3
On the
Admin
tab, expand
All
.
4
Click
Timezone Management
.
5
On the
Work
window, select the
General
tab.
6
In the
NTP Servers
area, click the
+
on the table icon bar.
7
In the
Add NTP Server
dialog box, type the IP address or hostname of the NTP server you want
to use for this Cisco UCS instance in the
NTP Server
field, and click
OK
.
8
Verify the time is accurate on the NTP server. View the time settings in the lower right corner of
the Cisco UCS Manager.
Related information
(see page 26)
Cisco UCS Manager GUI Configuration Guide
Removing an NTP server
The NTP server is used to ensure the correct time appears in the Cisco UCS Manager.
Managing compute resources
|
26
Содержание Vblock Systems 350
Страница 1: ...Dell EMC VxBlock and Vblock Systems 350 Administration Guide Document revision 1 8 October 2017 ...
Страница 114: ...Related information VMware vSphere Networking guide Managing VMware VDS 114 ...
Страница 122: ...Related information Cisco Nexus 1000V Troubleshooting Guide Managing the Cisco Nexus 1000V Series Switch 122 ...
Страница 156: ...4 On the Schedule tab schedule the task to run daily at 1 00 AM Backing up Cisco MDS switches 156 ...
