3.
4. Disconnect all the cables from the rear drive cage.
5. If installed, remove the
Steps
1. Loosen the captive screws that secure the rear drive cage to the system.
2. Push the guide hole tab to release the rear drive cage from the system and lift the rear drive cage away from the system.
Figure 61. Removing the rear drive cage
Next steps
1.
Installing the rear drive cage
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Before working inside your system
Steps
1. Align the guide and slot on the rear drive module with the slot and guide on the system.
2. Insert the rear drive module on top of the Riser 2a.
3. Tighten the captive screws to secure the rear drive cage to the system.
Installing and removing system components
83
Содержание PowerEdge R7525
Страница 25: ...Figure 14 Service information System overview 25 ...
Страница 79: ...Cable routing Figure 53 12x 3 5 inch Figure 54 8 x 3 5 inch Installing and removing system components 79 ...
Страница 80: ...Figure 55 16 x 2 5 inch Figure 56 24 x 2 5 inch with NVMe 80 Installing and removing system components ...