Figure 66. Closing the PCIe card holder latch
Next step
Follow the procedure listed in
After working inside your system
Removing expansion card from the expansion card riser
Prerequisites
1
Follow the safety guidelines listed in
2
Follow the procedure listed in
Before working inside your system
.
3
If applicable,
4
If applicable, disconnect the cables from the expansion card.
5
When removing a card from riser 2 or 3, ensure that the PCIe card holder latch is closed.
Steps
1
Pull the expansion card latch out of the slot.
2
Hold the expansion card by its edges, and pull the card until the card edge connector disengages from the expansion card connector
on the riser.
120
Installing and removing system components
Содержание PowerEdge R740
