Dell EMC PowerEdge R340, Инструкция по установке и обслуживанию

Страница: 65 / 116

Storage controller card
Removing the PERC card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions .
2. Follow the procedure listed in the Before working inside your system .
3. Remove the expansion card riser .
Steps
1. Remove the screw securing the blue release latch.
2. Rotate the blue release latch to disengage it from the PERC card.
3. Push the blue release latch until the tab on the latch clicks into the slot on the chassis.
4. Hold the PERC card by the edges and pull it to disconnect it from the connector on the system board.
5. Flip the PERC card and disconnect the cable from the PERC card.
Figure 45. Removing the PERC card
Next steps
1. Replace the PERC card .
Installing the PERC card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions .
2. Follow the procedure listed in the Before working inside your system .
3. Remove the expansion card riser .
Steps
1. Connect the PERC cable to the PERC card.
2. Flip and insert the PERC card in the connector on the system board.
3. Press the tab on the blue release latch to disengage it from the slot on the chassis.
4. Rotate the blue release latch until it locks with the PERC card.
5. Secure the blue release latch with a screw.
PowerEdge R340 installing and removing system components 65