Figure 50. Installing system battery
Next steps
1
Install the expansion card riser
.
2
3
Follow the procedure listed in the
After working inside your system
4
Confirm that the battery is operating properly, by performing the following steps:
a
Enter the System Setup, while booting, by pressing
F2
.
b
Enter the correct time and date in the System Setup
Time
and
Date
fields.
c
Exit
the System Setup.
d
To test the newly installed battery, remove the system from the enclosure for at least an hour.
e
Reinstall the system into the enclosure after an hour.
f
Enter the System Setup and if the time and date are still incorrect, see
section.
Optional internal USB memory key
An optional USB memory key installed inside your system can be used as a boot device, security key, or mass storage device. To boot from
the USB memory key, configure the USB memory key with a boot image and then specify the USB memory key in the boot sequence in
System Setup.
An optional USB memory key can be installed in the internal USB 3.0 port.
NOTE:
To locate the internal USB port on the system board, see the
System board jumpers and connectors
section.
78
Installing and removing system components
