Figure 24. Removing the LOM riser card
1
LOM riser card
2
screw (2)
3
standoff (2)
4
connector on the system board
Next steps
1
Install the LOM riser card.
2
Follow the procedure listed in the After working inside your system section.
Related links
Safety instructions
Before working inside your system
Installing the LOM riser card
After working inside your system
Installing the LOM riser card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
NOTE:
You must remove the LOM riser card to replace a faulty LOM riser card or service other components inside the system.
1
Follow the safety guidelines listed in the Safety instructions section.
2
Follow the procedure listed in the Before working inside your system section.
3
Keep the Phillips #2 screwdriver ready.
Installing and removing sled components
75
