Next steps
1
Follow the procedure listed in the After working inside your system section.
2
Enter System Setup and ensure that the
Internal SD Card Port
is enabled.
3
Check if the new SD card is functioning properly. If the problem persists, see the Troubleshooting an Internal SD Card section.
Related links
Safety instructions
Before working inside your system
Removing an internal SD card
After working inside your system
Troubleshooting an internal SD card
Removing the IDSDM card
Prerequisites
CAUTION:
Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that came with the product.
1
Follow the safety guidelines listed in the Safety instructions section.
2
Follow the procedure listed in the Before working inside your system section.
3
If connected, disconnect all USB devices.
4
If installed, remove the SD card(s).
5
Remove the SSD cage.
6
Keep the Phillips #2 screwdriver ready.
Steps
1
Remove the screws securing the IDSDM card to the SSD cage.
2
Lift the IDSDM card till it disengages from the standoff and slide the IDSDM card away out of the SSD cage.
CAUTION:
To prevent damage to the IDSDM card, you must hold the card only by its edges.
Installing and removing sled components
69
