Figure 66. Removing the front mounting front PERC module
Next steps
1.
Replace the front mounting front PERC module
.
Installing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
on page 26.
2. Follow the procedure listed in
Before working inside your system
3.
4. If installed,
5. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Align the front PERC module at an angle until the tray touches the slot in the system.
2. Slide and press the front PERC module connector with the connector on the drive backplane until firmly seated.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the front PERC module.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components
67
Содержание E68S
Страница 19: ...Figure 14 Service information System overview 19 ...
Страница 59: ...Cable routing Figure 53 12x 3 5 inch Figure 54 8 x 3 5 inch Installing and removing system components 59 ...
Страница 61: ...Figure 57 24 x 2 5 inch with NVMe Figure 58 16 x 2 5 inch Installing and removing system components 61 ...
Страница 62: ...Figure 59 8 x 2 5 inch with NVMe Figure 60 8 x 2 5 inch with NVMe 62 Installing and removing system components ...
