Figure 89. Installing the expansion card riser (Riser 4)
Next steps
1. If required, re-connect the cables to the expansion card.
2. Follow the procedure listed in
After working inside your system
on page 27.
3. Install any device drivers required for the card as described in the documentation for the card.
Removing expansion card from the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in the
on page 26.
2. Follow the procedure listed in the
Before working inside your system
3. If applicable, disconnect the cables from the expansion card.
4.
Remove the expansion card riser
.
Steps
1. Pull and lift the expansion card retention latch lock to open.
2. Pull the black card holder before removing the card from the riser.
3. Hold the expansion card by the edges. and pull the card until the card edge connector disengages from the expansion card
connector on the riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
116
Installing and removing system components
Содержание E68S
Страница 19: ...Figure 14 Service information System overview 19 ...
Страница 59: ...Cable routing Figure 53 12x 3 5 inch Figure 54 8 x 3 5 inch Installing and removing system components 59 ...
Страница 61: ...Figure 57 24 x 2 5 inch with NVMe Figure 58 16 x 2 5 inch Installing and removing system components 61 ...
Страница 62: ...Figure 59 8 x 2 5 inch with NVMe Figure 60 8 x 2 5 inch with NVMe 62 Installing and removing system components ...
