3.
4.
5. Disconnect all the cables from the rear drive module.
6. If installed,
remove the expansion card riser 3.
Steps
1. Using a Phillips #1 screwdriver, loosen the captive screws on the rear drive module.
2. Slide the rear drive module and lift it away from the system.
Figure 58. Removing the rear drive module
Next steps
1.
Replace the rear drive module.
Installing the rear drive module
Prerequisites
1. Follow the safety guidelines listed in
on page 25.
2. Follow the procedure listed in
Before working inside your system
3.
Steps
1. Align the rear drive module with the guide on the system board.
2. Lower the rear drive module and slide till it clicks.
3. Using a Phillips #1 screwdriver, tighten the captive screws on the rear drive module.
58
Installing and removing system components
