Dell EMC E26S Series, Руководство пользователя

Страница: 121 / 189

3. captive screw (2) 4. touch point (2)
5. NDC 6. back panel slots for Ethernet connectors
Related references
安全 说 明
on page 72
Related tasks
拆装系 统 内 部 组 件之前
on page 73
Removing expansion card risers on page 107
Installing the network daughter card on page 121
Identifier GUID-5231339C-BA70-4CA1-B90E-404CF30F30E3
Version 5
Status Released
Installing the network daughter card
CAUTION:
多 数 维 修只能由 经认证 的 维 修技 术 人 员进 行。 您 只能根据 产 品 说 明文件中的授 权 ，或者在 联 机或 电话 服 务 和支持
团队 的指 导 下 进 行故障排除和 简单维 修。任何未 经
Dell
授 权 的服 务 所 导 致的 损 坏均不在保修范 围 之列。 请阅读 并 遵循 您 的
产 品附 带 的安全 说 明。
CAUTION: If the GPU card is installed, you cannot install the 10 GbE Network Daughter Card (NDC).
1. Follow the safety guidelines listed in the Safety instructions section.
2. Follow the procedure listed in the Before working inside your system section.
3. Keep the Philips #1 screwdriver handy.
NOTE: If the
系 统
has three PCIe cards, ensure that you install the PCIe cooling shroud in your
系 统
.
1. Orient the NDC so that the Ethernet connectors fit through the slot in the back panel.
2. Align the captive screws at the back-end of the card with the screw holes on the system board.
3. To ensure that the connector on the card is in contact with the connector on the system board, press the touch point on the
card.
4. Tighten the two captive screws to secure the NDC to the system board.
5. Install the expansion card riser 3.
安装和卸下系 统组 件
121