Dell EMC 6WDJR, Инструкция по установке и обслуживанию

Страница: 81 / 129

Figure 55. Installing the heat sink
Next steps
1 Install the air shroud .
2 Follow the procedure listed in the After working inside your system .
Optional IDSDM or vFlash module
The IDSDM or vFlash module combines the IDSDM and/or vFlash features into a single module.
NOTE: The write-protect switch is on the IDSDM or vFlash module.
Removing the optional IDSDM or vFlash card
Prerequisites
1 Follow the safety guidelines listed in Safety instructions .
2 Follow the procedure listed in Before working inside your system .
3 Remove the air shroud.
4 If you are replacing the IDSDM/vFlash card, remove the MicroSD cards .
NOTE: Temporarily label each SD card with its corresponding slot number before removal. Reinstall the SD cards into the
corresponding slots.
Step
Holding the pull tab, lift the IDSDM/vFlash card out of the system.
Next step
NOTE: If you are replacing the IDSDM or vFlash module, remove the MicroSD cards.
1 Replace the IDSDM/vFlash module.
Installing and removing system components 81