16
Part Number: 9295040 07/17
Installation
Section 2
T-2 Tray Slide Installation
Universal Bottom Support for 12” x 20” and 18” x 26” pans
Installed T-2 tray slide with both size pans
Sysocm amc
T-2
Sltdc Soylc
Tray
SuppNro Soylc
Bottom
CNmpaotblc wtoh 12” x 20” Pans
Yes
CNmpaotblc wtoh 18” x 26” Pans
Yes
• The T-2 (Universal) tray slide system is designed to
support both 12” x 20” and 18” x 26” pans by the
bottom.
• The tray slide is an L shaped piece of formed stainless
steel.
• Each set of tray slides is mounted at the same height
across a door section.
• For each pan, one set of two (2) tray slides is used.
Centerline Spacing
2.0”
3.0”
4.0”
5.0”
6.0”
Maximum Tray Slides for a Full Section
23
15
12
9
8
Maximum Tray Slides for a Half Section (Top or Bottom)
10
7
5
4
4
T-2 Tray Slide System
T-2 Installation Instructions
1. For each pan, two (2) tray slides will be used. Each tray
slide must have another tray slide at the same height,
on the opposite side of the door section. Mount the tray
slides onto the pilasters by sliding the tabs down into
the pilaster cutouts. Make sure that all tabs are engaged
securely to each pilaster.
NOTE: A dead-blow hammer is recommended to seat the tab
into the cutouts.
Pilas
ter
Slider
2. Verify that all tray slides are lined up evenly.
NOTE: An easy check to verify correct installation is to slide
a pan onto each slide. If the pan is held securely, and is level
inside the door section, the installation has been successful.
