3
GB
INSTRUCTION MANUAL
IMPORTANT SAFEGUARDS
•
Please read all the instruction manual before use and save it for future references.
•
Before first switching on check that the voltage indicated on the rating label corresponds
with the mains voltage in your home.
•
For home use only. Do not use for industrial purposes. Use the appliance only for its
•
Do not use outdoors or in damp area.
•
Do not immerse the appliance and the cord in water or other liquids.
•
Do not use the appliance in immediate proximity to
а
bath,
а
shower or
а
swimming pool.
•
Never pull the cord while disconnecting from the power outlet; instead, grasp the plug
•
Do not allow the cord to touch sharp edges and hot surfaces.
•
Always unplug the appliance from the power supply when not in use.
•
Do not operate the appliance with damaged cord or plug, or after the appliance
malfunctions, or has been dropped or damaged in any manner. To avoid the risk of
electric shock, do not disassemble the appliance; take it to a service center for
examination, repair or mechanical adjustment.
•
This appliance is not intended for use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliances by a
person responsible for their safety.
•
Children should be supervised to ensure that they do not play with the appliance.
•
Do not leave appliance unattended while operating.
•
The appliance must be used only in the upright position.
•
Unit surface temperature of the appliance is high, thus do not touch it, except the handle.
•
Operating unit should be far away from the flammable or easy bulging under high
•
The heater must not be located immediately below a socket-outlet.
CAUTION:
•
To avoid a circuit overload, do not operate another high wattage appliance on the same
circuit.
FLOOR PLACEMENT
•
Turn the heating device, attach the feet to the bottom of the heating device, make sure
that bolt holes are aligned correctly, and then fasten the bolts tightly.
•
Put the heating device on the floor.
WALL PLACEMENT
•
Fix the clamps on the wall using available bolts and nuts.
•
Place the heating device so that the gap between the bottom of the device and the
floor is at least 50 cm, and the distance between the device and upholstery materials
and curtains is at least 1 m. Fasten rubber insertions on the back panel of the device
so that the clamps on the wall can completely slide in the channels on the back of
the heating device. Place the locking clamps on the surface of the channels of the device
and available screws. It will protect the device from an accidental removal from the wall.
temperature objects.
only and pull to disconnect.
intended use.
