Del ozone spa solar eclipse, Руководство по установке

Страница: 7 / 12

SES Installation & Operations Manual
4
NOTE: UV Lamp CONTAINS MERCURY. Manage in accordance with
disposal laws. See www.lamprecycle.org .
6B. Installing the UV Lamp
i. Make sure to handle the new lamp by the ceramic endcaps
and clean the UV Lamp before installation if needed.
ii. Slowly place the UV Lamp into the Lamp Retainer until the top
of the UV Lamp is pushed past the tabs on the Lamp Retainer.
iii. Connect the Lamp Connector to its corresponding part in the
Ballast Assembly.
6C. UV Reactor Service and Maintenance
The UV Lamp is housed in a Quartz Tube. If the Quartz Tube
becomes dirty, its ability to transmit rays from the UV Lamp will be
diminished and decrease system performance. The Quartz Tube
should be removed from the UV Reactor at least once a year or
during a routine spa water change for inspection and cleaning if
necessary.
6D. Quartz Tube Removal and Cleaning
CAUTION: Wear proper eye and skin protection for servicing
glass components.
NOTE: Damage caused by broken quartz tubes is not covered under
the Spa Solar Eclipse Limited Warranty.
CAUTION: If broken glass is trapped in the pool system, do not
operate the pool. Contact a service professional to have the
glass removed.
i. Make sure the pool is shut down and the system has cooled
before performing maintenance on the Quartz Tube. If you have
installed Isolation Valves, close them before servicing. If you
do not have Isolation Valves, the pool must be drained below
where the Spa Solar Eclipse is mounted.
ii. Remove the Enclosure Cover and UV Lamp as described in
Section 4C and set aside.