Del Morino RES, Руководство по эксплуатации и обслуживанию

Страница: 11 / 39

11
T
ANK OIL LEVEL- TANK OIL AND FILTER SUBSTITUTION
To refill or change oil use only HYDRAULIC OIL Type NUTO H46, tank capacity: RES10 : 10L, RES15-20.30
: 13 L, RES 50 : 45 L.
Refilling or replacement of oil must be made at the intervals prescribed in diagram “A”.
a) To verify the oil level in the tank, operate as follow :
1) Put the machine on level surface and verify the oil level through the spy “A”.
2) If level is low, remove the plug “B” and refill using proper oil type. Use only new oil.
3) When the oil level is correct replace the plug “B”.
b) To change oil and filter in the tank, operate as follow :
1) Remove the plug “B”.
2) Put a container under the tank then remove the discharge plug “D”.
3) Remove the cover “C” of the filter case by removing the four screws and take out the old filter.
4) Put the new filter in place and replace the filter cover, check the position of the seal and then
tighten the four screws.
5) Screw in and tighten the discharge plug “D”.
6) Fill oil in the tank through the plug “B”.
7) When the level is correct replace the plug “B”.