Dekema AUSTROMAT 624, Руководство по эксплуатации, Страница: 32 / 155

4. Start-up AUSTROMAT
®
624 / 644
32 Operating Instructions (Version 01/2012)
4.4. Connect the firing oven to the network (optional)
NOTE:
This functionality is available as an option.
•
The options that are enabled for your firing furnace can be found in the menu
Setup > Furnace ID > Options (see section 5.7.2.1).
•
You can find information on enabling options in section 7.5.
•
The unit shall not be connected directly to TNV networks.
Overview of the procedure
1. Determine the IP address of the firing furnace (see section 4.4.1).
2. Set up remote access to the firing furnace (operation):
• Access through a browser. To do this, Java must be installed on a computer and the
browser must be a Java-enabled (see section 4.4.2).
• Access via a VNC program. A VNC program must be installed on your computer (see
section 4.4.3).
3. Set up a permanent IP address for the firing furnace (see section 4.4.4).
4. Establish access rights for users of the firing furnace (see section 4.4.5).
5. If desired: establish the type of remote access (through a browser or VNC program) (see
section 4.4.6).
4.4.1. Determine the IP address
NOTE:
Consult your network administrator if you are uncertain.
1. Make sure that the firing furnace is connected to the Ethernet (interface for the network
cable on the back of the unit),
2. Turn on the firing furnace and confirm any error messages. After the furnace is turned on,
the Program Manager automatically appears.
3. Click on [Setup] > [Network] in the Program Manager. The window “Network settings”
opens.