5
Face shield with CLIP
The
APS…SC face shield
is positioned above the
safety helmet
and both clips are snapped into the slots on the helmet. Check that
they are secure (see Figure 1).
Note concerning the replacement of the visor holder:
The visor holder can be replaced if necessary or if it is damaged (see accessories, Table 2, page 6). To do so, the visor holder and visor
should be carefully removed from the safety helmet.
Remove the visor holder from the visor as follows:
Â
APS… type
: Turn the fi ve locking noses so that they fi t through the relevant slots in the visor. Then remove the visor from the visor
holder.
For both types, the visor is inserted in the new visor holder following this procedure in reverse order.
Important
: Do not remove the chin protector of the visor. This is a permanent fi xture!
Figure 1
Face shield with CLIP
APS… SC face shield
clip
locking screw
locking nose
slot
Important:
Completely snap both clips
into the slot of the helmet
and make sure they are
secure!
clip
locking screw
integrated locking mechanism
APS T…SC face shield
Содержание APS 12C FS
Страница 131: ...11 ...