3
www.degreeC.com • 603.672.8900 or 1.877.334.7332
°C Breeze User Manual
Unpacking
& Inspection
Open the shipping carton, open the °C Breeze case
and confirm all components are inside and intact.
If any of the equipment is damaged or not working
properly, contact [email protected] immediately.
Your °C Breeze instrument contains:
• Carrying case with keys
• °C Breeze Instrument
• Extension tube
• 12V rechargeable battery
• Battery charger and international plugs
• 500 ml bottle of °C Breeze Fog Fluid
• °C Breeze user manual
• °C Breeze Quick Start Guide
Initial Setup
• Remove reservoir cap and fill the unit
with °C Breeze Fog Fluid.
• Replace reservoir cap and do not overtighten.
• Charge the battery for 8 hours by plugging
the adapter onto the battery and into
a grounded electrical outlet.
• The green LED on the charger should
illuminate during charging.
• Subsequent charge time is 2-3 hours.
• Align the battery’s electrical terminals with
the receiving terminals inside the Cbreeze,
and slide inside, making sure the battery
clip latches in place.
• The charge will last approximately 10-15
minutes depending on fog quantity selected.
Operation
The °C Breeze operates with or without the extension tube
and requires almost no warm-up time. The user can set the
unit’s two side-mounted toggle switches in order to adjust to
an operational preference.
Momentary vs Latching Mode:
This toggle switch setting determines how the push button
will operate. In Momentary Mode (
←
), the fog flow will start
when the button is pressed, and stop when the button is
released. In Latching Mode (
→
), the fog will flow when the
button is pressed and released, and will keep running until
the button is pressed a second time. Move the switch as
indicated by the label on the °C Breeze.
High vs Low Flow Mode:
This toggle switch sets the fog fluid consumption rate, in
order to maximize battery life between charges. In Low Flow
Mode (
←
), the consumption rate is reduced by approxi-
mately 50%, and the runtime is extended 30%. In High Flow
mode, the unit outputs the maximum fog volume possible.
Begin by pressing the button on the handle, and the green
LED will turn on. Fog will be produced within 1 second.
When fog is turned off, the green LED will flash for approxi-
mately 7 seconds while the unit shuts down.
Operation toggle switches
Filling the unit
