1)
Drive landroller onto level ground, straight behind the
tractor.
•
Ensure there is plenty of room behind and to the sides
of the landroller for backing into field position.
2)
Remove all five red transport bars.
(4 located on cylinders,
and 1 on float hitch)
.
•
Place the transport bars onto the storage brackets
provided and secure with lock-pin.
Note:
You may need to activate (extend) the hydraulic cylinders
to allow removal of the cylinder transport bars.
3)
Raise the floatation plate to allow an 1-1/4” gap using
the ratchet jack to place it into field “float” position.
Float position will allow the hitch pole to contour more
effectively and prevent strain and possible damage to
the machine.
4)
Activate the End Wheel Circuit to start lowering the
drums to the ground but
stop lowering
before the drums
make contact with the ground.
A
B
Connect Hydraulics
Backing Into Field Position
142691 v1.0
1-1/4”
2
2
3
ROLLER LIFT CIRCUIT..............
End Wheel Cylinders
1
QUICK-START GUIDE
*
for
LANDROLLER
|
45
|
51
* Refer to operators manual for complete safety and operation info.
TO
BE ELIGIBLE FO
R
YO
UM
UST REGISTE
R
WARRANTY
REMEMBER!
You must complete
Product
Registration
to be eligible for
Warranty.
CENTER WHEELS..................
Center Wheel Cylinders
2
1
5
5
5)
Slowly back-up the landroller spreading the wings until
they are almost fully in field position.
8)
The roller is now in field ready position.
8
7)
Continue backing up until Swing-Arms lock in place.
7
6)
Fully lower the drums to the ground and raise endwheel
struts by closing the hydraulic cylinders & .
6
6
7
1
2
4
