Page 10
Troubleshooting
5
Although the iron is plugged in, base
does not heat up.
x
The appliance may be improperly
connected. >>> Check the plug and power
cable of the iron.
x
The temperature setting button may be at
the Min. position. >>> Turn the
temperature setting button up to the steam
sign.
Iron does not generate steam.
x
Water reservoir may not contain a
sufficient amount of water. >>> Fill the
water reservoir with water up to Max level.
x
The steam adjustment button (6) may be
at the “0” position. >>> Turn the steam
adjustment knob to the steam position.
>>> Iron base may not be hot enough.
"Anti-Drip" system which prevents water
dripping may be active. Turn the iron
temperature setting button up to the
steam sign. Seat the iron in a vertical
position and wait for the base to heat up.
Shock Steam – Vertical Steam does not
function.
x
These functions may have been used too
frequently in a very short period of time.
>>> Keep ironing at a horizontal position
and wait for a while before using the shock
steam function again. >>> Iron base may
not be hot enough. Turn the iron
temperature setting button up to the steam
sign. Seat the iron in a vertical position
and wait for the base to heat up.
Water drops fall down onto the fabric
during ironing.
x
You may not have fully closed the water
refill lid . >>> Close the water refill lid
completely.
Sediments and particles drop off from the
base during ironing.
x
If the water you use for your iron is too
limy, such sediments may form. >>> Use
the self-clean function once and repeat if
necessary. In your next ironing session,
add soft water into your appliance.
Stains on the ironing base.
x
Wet garments might have been ironed and
the iron base has lime stains. >>> After
the appliance cools down to a satisfactory
level, wipe the iron base with a microfiber
knitted or cotton cloth soaked in vinegar.
Technical data
Power supply:
220-240 V~, 50-60 Hz
Power consumption:
1600W - 2000W
Technical and design modifications
reserved.
Iron emits an odor or smoke
Iron gives off an odor when switched on for
the first time. Oils used during manufacture
need to be burnt off allow ten minutes for
odor to disappear.
Iron does not heat
The iron should be plugged into a 230 Volt,
AC electrical outlet only. The temperature
dial must be set at the desired temperature.
Iron does not steam
The water tank many be empty. Add water
as per instructions on page 7. Allow the iron
to heat, and then set the steam dial to the
steam setting.
Burst of steam feature does not work
The water tank must be at least 1/4
full .Temperature must be set to steam
position. Iron should be in the horizontal
position. Prime pump briefly. Allow a short
pause between shots. Be sure to fully
depress the burst of steam button.
Spray mist feature does not work
The water tank must be at least 1/4 full. Fill
the iron as described in the section “how to
fill the water tank”.
Iron is leaking
The variable steam dial must be set on low
until the iron is hot. The temperature setting
is too low to produce steam. If the burst of
steam is used too much, allow iron to reheat.
The appliance drops water after it cools
down or is stored.
x
You may have left the iron in a horizontal
position while there is water in its
reservoir. >>> Empty the water reservoir.
