Page 9
3 Installation
Installation is the buyer’s responsibility. The
manufacturer accepts no liability for this
service. Any action that the manufacturer
has to take as a result of an erroneous
installation will not be covered by the
warranty.
The necessary installation, including gas and
electrical connections, must be carried out
by qualified personnel in accordance with
current and local regulations. An installation
by an unqualified person may constitute a
hazard.
Installations carried out by unauthorized
persons will void the warranty.
The manufacturer shall not be held
responsible for injury to persons or
damages arising from procedures carried
out by unauthorized persons or due to
non compliance with these provisions.
Preparation of location and
electrical and gas installation for
the appliance falls under the
customer’s responsibility.
DANGER
The appliance must be installed in
accordance with all local gas and/
or electrical regulations.
DANGER
Prior to installation, visually
check if the appliance has any
defects on it. If so, do not have
it installed.
Damaged appliances are a safety
risk.
Before installation
This appliance is designed for installation in
a domestic worktop. A safety distance must
be left between the appliance and the
kitchen walls and furniture. See figure
overleaf (values in mm).
x
This appliance can also be used in a free
standing position. Allow a minimum
distance of 750 mm above the hob
surface.
x
(*) If a cooker hood is to be installed
above the appliance, refer to the cooker
hood manufacturers instructions regarding
installation height (min 650 mm)
x
Remove packaging materials and
transport locks.
x
Surfaces, synthetic laminates and
adhesives used must be heat resistant
(100 °C minimum).
x
The worktop must be aligned and fixed
horizontally.
x
Cut the aperture for the hob in the
worktop as per installation dimensions.
This appliance uses LPG (Liquid
petroleum or bottle gas)
This appliance requires an operating
pressure of 2.8-3.0 kPa. A suitable LPG
regulator that complies with the
requirements of SANS 1237 must be
used.
The manufacturer and the seller do not
accept responsibility for any damage due
to incorrect installation or gas
connection.
x
Gas bottles should be located outdoors in
a suitable ventilated lock-up.
x
The connecting hose should not exceed
125 cm in length.
x
An appliance without a flame failure
device may only be used with a free
standing cylinder placed adjacent to but
not closer than 300 mm to the appliance.
