Page 10
The connection must comply with national
regulations. The mains supply data must
correspond to the data specified on the type
label of the appliance.
Risk of broken glass!
Do not put the ceramic hob down
on a corner or edge.
DANGER Risk of electric shock!
Before working on the electrical
installation, disconnect the
appliance from the mains supply.
DANGER Risk of electric shock,
short circuit or fire by
unprofessional installation!
The appliance may be connected
to the mains supply only by an
authorized qualified person and
the hob is only guaranteed after
correct installation.
Electrical connection
Connect the appliance to a grounded outlet/
line protected by a fuse of suitable capacity
as stated in the "Technical specifications"
table. Have the grounding installation made
by a qualified electrician. The manufacturer
and the seller do not accept responsibility
for any damage due to incorrect installation
or electrical connection.
Safety installation
x
A removable horizontal board must be
fitted below the hob and 75mm away from
the worktop bottom face.
x
Space between this board and the
appliance must be empty and no objects
may be stored or kept there.
x
This board will effectively shield the user
from the base of the hob which gets hot
during use. The board needs to be
removable for service purposes as the
hob, once installed, can only be loosened
from below.
x
If the appliance is installed with a side
adjacent to a vertical kitchen cabinet, the
distance between the edge of the
appliance and that of the cabinet side
must be a least 150mm. The distance
between the back wall and the rear edge
of the hob must be at least 55mm.
803
470
Earth leakage
This hob should not be connected through
an earth leakage system.
Refer to S.A.N.S. 10142
Connection to the power supply must be
carried out by a licensed electrician, who will
ensure that the hob is correctly connected
and safely earthed. The rated current is
printed on the serial number label attached
to the base cover.
The hob must be connected to the mains
through a double pole isolating switch which
has a minimum clearance between the
contacts of 3 mm in both poles.
A means for disconnection must be provided
in the fixed wiring.