Page 4
Refer to the nearest Authorised Service
Agent for installation of the machine. Review
the information in the user manual and
ensure that the electricity, water supply and
water drainage systems are appropriate
before calling an Authorized Service Agent.
If they are not, call a qualified technician and
plumber
to
have
any
necessary
arrangements carried out.
3.1 Appropriate installation location
• Place the machine on a rigid floor that has
sufficient load carrying capacity. Do not
place it on a long pile rug or similar surfaces.
• Do not place machine on the power cable.
• Do not install the product at places where
the temperature may fall below 0ºC.
• Place the product at least 10 mm away
from the edges of other furniture.
3.2 Removing packaging reinforcement
Tilt the machine backwards. Remove the
packaging reinforcement by pulling on the
ribbon.
3.3 Removing the transportation locks
3 Installation
1. Loosen all the bolts with a suitable
spanner until they rotate freely (C).
2. Remove transportation safety bolts by
turning them gently.
3. Attach the plastic covers supplied in the
User Manual bag into the holes on the rear
panel. (P)
Preparation of location, electrical, tap water
and waste water installations of the machine
are the customer's responsibility.
Warning:
Installation
and
electrical
connections of the machine must be carried
out by an Authorized Service Agent. The
Manufacturer shall not be held liable for
damages that may arise.
Warning:
Prior to installation, visually check
if the machine has any defects on it. If so, do
not have it installed. A damaged machine is
a safety risk.
Ensure that the water inlet and discharge
hoses as well as the power cable are not
folded, pinched or crushed, during or after
installation or cleaning procedures.
Warning:
Do not remove the transportation
locks before taking out the packaging
reinforcement.
Warning:
Remove the transportation safety
bolts before operating the washing machine
to avoid damaging the machine.
The water supply pressure required to run the
machine is between 1 - 10 bars (0.1 – 1 MPa).
It is necessary to have 10 – 80 litres of water
flowing from a fully open tap per minute to have
your machine run smoothly. Attach a pressure
reducing valve if water pressure is higher.
If only the single (cold) water-inlet and not the
hot water inlet is going to be used, the supplied
stopper must be installed to the hot water valve
before operating the machine. (Only applies to
machines supplied with a blind stopper).
Warning:
Models with a single water inlet
should not be connected to the hot water tap.
In such a case the laundry will be damaged or
the machine will switch to protection mode and
will not operate.
Warning:
Do not use old or used water inlet
hoses on the new product. It may cause stains
on your laundry.
Keep the transportation safety bolts in a safe
place to reuse when the washing machine
needs to be moved again in the future.
Never move the product without the
transportation safety bolts securely in place!
