2
Table of Contents
Table of Contents ......................................2
Safety Information ....................................2
Warranty ...................................................3
Pre-Installation .........................................4
Installation ................................................7
Troubleshooting ........................................8
Safety Information
WARNING
□
Risk of fire/electric shock. If not qualified, consult an electrician.
□
Disconnect power at fuse or circuit breaker before installing or servicing.
CAUTION
□
Connect fixture to a 120-volt, 60 Hz power source. (Any other connection voids warranty.)
□
Fixture should be installed by persons with experience in household wiring or by a qualified electrician. The
electrical system and the method of electrically connecting this fixture to it must be in accordance with the
National Electrical Code and local building codes.
□
Mount fixture to a grounded, recessed-mounted standard junction box marked for use in wet locations.
□
Suitable for wall mount or eave mounting only. Not suitable for ground mount installation.
□
For proper operation and protection against damage, the motion sensor head adjustment knobs must be
facing the ground.
□
Do not mount below 5 feet.
□
MINIMUM 75°C SUPPLY CONDUCTORS.
□
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation. Under Part 15 of the FCC Rules, any changes or
modifications to the motion detector described in this instruction sheet that are not expressly approved by
Eaton could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the instructions, may cause harmful
interference to radio communications. However, there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
WARNING: FCC Regulations state that any unauthorized changes or modifications to this equipment not
expressly approved by the manufacturer could void the user’s authorization to operate this equipment.
