6
Installation
1
Determining the mounting
location
NOTE:
The light fixture should be mounted approximately
8 ft. (2.4 m) above the ground. If the light fixture is
mounted higher than recommended, aiming the sensor
down will reduce the coverage area.
NOTE:
Ensure the fixture and the solar panel are located
close enough together for the cord to reach.
□
Determine the mounting location – wall or eave
mount.
□
Position the lamp heads (A) in the general
direction of the desired light coverage.
□
If needed, rotate the motion sensor (C) so the
controls face the ground after installation.
THIS SIDE UP
Wall Mount
THIS SIDE UP
Eave Mount
THIS SIDE UP
2
Installing the mounting plate
NOTE:
Make sure there is enough vertical space above
the mounting plate to allow the light fixture to be mounted.
□
Place the mounting plate (D) against the
mounting surface and ensure the mounting
plate (D) is level. Mark the hole locations.
□
If mounting to a wooden surface, drill two
3/32 in. holes into the mounting surface.
Install the two mounting screws (BB)
through the mounting plate (D) and into
the mounting surface.
□
If mounting to wall board or brick, drill two
7/32 in. holes into the mounting surface.
Insert the wall anchors (CC) and attach the
mounting plate (D) using the two mounting
screws (BB).
3
Mounting the light fixture
□
Slide the rear of the light fixture (B) down onto
the mounting plate (D) until it snaps into place.
UP
A
D
BB
B
D
