HOMEDEPOT.com
Please contact 1-866-308-3976 for further assistance.
210537-02A
INITIAL BATTERY CHARGE
IMPORTANT: Ensure the solar panel cord is firmly attached to the light fixture cord with no space between the two
connectors.
IMPORTANT:
The solar panel requires full, direct sunlight to charge the battery. Clouds, rain, snow, and other weather conditions may not allow the
solar panel to completely recharge the battery. Other obstructions such as buildings or trees may block the sun as well.
When installing the solar panel, make sure it is aimed as described below with a minimum amount of obstructions. If possible, mount the panel facing
toward the southern sky.
□
PRIOR TO USE, the battery will require 2 to 5 days of full sun to completely charge with the control switch in the OFF
position.
Plug the solar panel cable into the connector extending from the bottom of the battery case. If possible,
aim the solar panel toward the south and tilt it approximately 50° from horizontal. If the solar panel cannot be aimed
toward the south, then tilt the panel approximately 30° if possible.
□
Actual operating time will vary depending upon how frequently the light is turned on by the motion sensor.
□
Solar lighting is not designed to equal standard 120V lighting. The amount of light output is reduced to allow the sun
time to fully recharge the battery between lighting cycles.
□
Solar collection is only effective in direct sunlight. Every hour the light is on requires a minimum of 16 hours of
sunlight charging. Solar panels collect less than 10% of the sun’s energy.
To ensure the maximum RUN TIME solar performance:
□
Set the time dial HALFWAY between 5S and 60S.
W
TE
ST
5S
OF
F
60
S
Troubleshooting
Problem
Possible Cause
Solution
The light fixture is not
charging.
The solar panel is not
COMPLETELY
connected to the light fixture.
Ensure the solar panel connector is
fully
inserted
into the light fixture connector.
There should be
NO gap
.
The light fixture flashes ON
and OFF repeatedly.
The light fixture is in TEST mode.
Set the light fixture motion sensor to the
OFF or 5S-60S (5 second to 60 second)
setting.
The light fixture is charging
but does not come on at night.
The motion sensor is set to the OFF
position.
Set the light fixture motion sensor to the
5S-60S (5 second to 60 second) setting.
