This is best achieved by carefully marking a line along
the centre of the panel, using a felt-marker or line-
paint, so you are left with complete cells in the same
configuration as a normal panel end.
It is advisable to cover the end cells with a scaffold plank or
similar. Fill to the edge of the plank, leaving the cells below
the plank empty.
Then remove plank and cut cells next to the glue joints.
Remove the frame as usual and keep the unfilled section
of Profile 300. Use this at the end of the run to complete
the layer.
Then place a new Profile panel on the frame and join to
the filled half panel.
Profile 300 1.50m
There are three distinct differences between the Profile
300 1.25m high and the 1.50m high during construction;
1.The Profile 300 1.50m has an extra layer, using the
Profile 300:06 on top.
2. Connect all the end cells between panels with a cord
tied with a reef knot.
The same can be achieved when using pins.
3. Panel joints should be staggered by cutting the end
panels on each layer of a construction. Each layer should
be cut 1m shorter than the layer below to achive the
staggered joints.
6
