HD Multi SeaCam
®
Operator’s Manual
5
Safety Symbol
In this operator’s manual and on the product, safety symbols are used to communicate important
safety information. This section is provided to improve understanding of these symbols.
This is the safety alert symbol. It is used to alert you to potential personal injury hazards. Obey all safety messages that follow this symbol to
avoid possible injury or death.
DANGER
indicates a hazardous situation which, if not avoided, could result in death or serious injury.
WARNING
indicates a hazardous situation which, if not avoided, could result in damage to the product or bodily harm.
CAUTION
indicates a hazardous situation which, if not avoided, could result in minor or moderate injury.
NOTICE
indicates information that relates to the protection of property.
This symbol means read the operator’s manual carefully before using the equipment. The operator’s manual contains important information
on the safe and proper operation of the equipment.
This symbol means always wear safety glasses with side shields or goggles when handling or using this equipment to reduce the risk of eye
injury.
This symbol indicates the risk of electrical shock.
DANGER
!
WARNING
CAUTION
NOTICE
General Notes and Warnings
The HD Multi-SeaCam supports a variety of connectors.
Be sure to verify pin-out orientation before use.
It is very important when preparing the system for
deployment that the cable, at both the camera and
topside ends, be carefully dressed to provide complete
strain relief to the connectors. Failure of the strain relief
provisions will almost certainly damage the connectors
and possibly other elements of the system.
DANGER
Do not operate any high voltage electrical
equipment in or around water without using
a Ground Fault Interrupt circuit (GFI) and an
isolation transformer, especially when divers
are in the water.
WARNING
Never place the camera in a vice or other hard
clamping tool. Should it become necessary
to hold the camera more tightly than can be
managed by hand, use a clean, good quality
strap wrench.
Pre and Post Dive Inspection
Rinse your HD Multi-SeaCam in fresh water after use in
saltwater.
Always check to make sure that the rear bulkhead con-
nector assembly is secure before deployment.
Before and after each deployment, check the following
areas for damage, wear or corrosion:
●
Rear bulkhead connector assembly
●
Video cable
●
Front window
●
Retaining cowl
WARNING
After each deployment, carefully check to
make sure the camera has not flooded. It is
possible for the camera to partially flood and
then reseal itself while underwater. Upon
surfacing, the camera can become internally
pressurized, which may be potentially
dangerous. Additionally, if the power remains
on when the camera has partially flooded, it
is possible for electrolytic generation of an
explosive mixture of hydrogen and oxygen