background image

REGULATORY NOTICES

This device complies with part 15 of the FCC rules. Operation is subject to the following two 
conditions: (1) This device may not cause harmful interference, and (2) this device must accept 
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital 
device, pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. This equipment generates, 
uses, and can radiate radio frequency energy and, if not installed and used in accordance 
with the instructions, may cause harmful interference to radio communications. However, there 
is no guarantee that interference will not occur in a particular installation. If this equipment 
does cause harmful interference to radio or television reception, which can be determined by 
turning the equipment off and on, the user is encouraged to try to correct the interference by 
one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Changes or modifications not covered in this Guide must be approved in writing 
by the manufacturer’s Regulatory Engineering Department. Changes or modifications made 
without written approval may void the user’s authority to operate this equipment.
FCC Radiation Exposure Statement: This equipment complies with FCC radiation exposure limits 
set forth for an uncontrolled environment. This equipment should be installed and operated with 
minimum distance 20cm between the radiator and your body.
This device and its antenna(s) must not be co-located or operating in conjunction with any other 
antenna or transmitter except in accordance with FCC multi-transmitter product procedures.

Содержание WFI-19001









Отзывы: