10
EN
EN
3. Operating and Programming
Turn the robot’s Bottom Power Switch to the
ON position. “I”=power ON; “O”=power OFF.
DEEBOT is powered ON when the AUTO
Mode Button glows a continuous BLUE.
Power ON
3
P l a c e D E E B OT o n t h e C h a r g i n g D o c k
mak ing sure the Charging Contacts on
DEEBOT and the Charging Dock Pins make
a connection.
Charge DEEBOT for at least 4 hours before
first use.
Charge DEEBOT
4
*
*
*
*
*
*
*
*
*
W h e n D E E B O T i s n o t c l e a n i n g , i t i s
suggested to keep it powered ON and
charging instead of powered OFF.
Make sure to turn the robot’s Bottom
Power Switch to the ON position before
charging. (“I”=power ON; “O ”=power
OFF. The robot’s default setting is “O”.)
DEEBOT is powered ON when the AUTO
Mode Button glows a continuous BLUE.
AUTO Mode Button blinks when DEEBOT
is charging. AUTO Mode Button stops
glowing when DEEBOT is fully charged.
R e m o v e t h e Wa t e r R e s e r v o i r b e fo r e
charging DEEBOT.
Remove the robot’s battery if it will not be used for a long time. In case of battery leakage,
please remove the battery and wipe the battery slot clean while wearing protective gloves.
If battery is fully discharged or not used for a long time, its capacity may decrease and need
to be reactivated.
To reactivate the battery: Place the robot on the Charging Dock by hand, remove after
charging for 3 minutes; repeat 3 times, then charge normally for 3-5 hours.
DEEBOT uses a long life battery, and does not require frequent replacement. To replace the
battery, contact Customer Service or follow the below instructions:
a. Unscrew the Battery Cover Screws, remove Battery Cover.
b. Remove the battery and disconnect the fasteners.
c. Connect the corresponding positive and negative fasteners on the new battery. Insert the
new battery, reassemble the Battery Cover and screw in the Battery Cover Screws.
