Use the images below to locate the hold down clamps for each truck bed length.
The end hold down clamps should be
For applications with the bungee box,
as close to the end as the truck bed
the hold down clamp needs to bridge the
5
5.5' BED
6' BED
8' BED
as close to the end as the truck bed
the hold down clamp needs to bridge the
allows, but still completely in the
joint between the rack section and the
channel of the extrusion.
bungee box equally.
Note: Some trucks will have a center stake hole that will not allow the hold down clamp to bridge the
joint of the main housing and bungee box. In this case, it is important to make sure that the two
hold down clamps are installed on the front main housing and two hold down clamps are installed
on the rear main housing (One as far forward as possible and one as far back as possible).
