DeDietrich DVH1044J, Инструкция по эксплуатации

Страница: 7 / 32

Check the rinse aid level
(On models with water softener system only.)
Electric indicator on control panel (if provided).
If there is no salt warning light in the control panel
(for some models), you can estimate when to fill the salt into
the softener by the number of cycles the dishwasher has run.
Check the regeneration
salt level
Load the baskets
Select a programme
T urn on the water tap ,close the door . The machine will start working after about 10 seconds. Running the dishwasher
Switch off the appliance
Turn off the water tap,
unload the baskets
Fill the detergent dispenser
Warning: wait a few m inutes (abou t 15 m inutes ) befo re unlo ading the dis hwas her to avoid
han dling the dis hes an d uten sils w hile th ey are still h ot and more s uscep tible t o brea k.
The dishe s will also dry bett er. Firs t start unloa ding th e lowe r bask et.
Changing the programme
Adding forgotten dishes in
the dishwasher.
To lo ad the baske ts, ref er to th e sect ion en titled Load ing th e Dish washe r Bask ets .
“ ”
Press the Programme Button until the selected programme lights up.
( See the section entitled
Operation instruction )
“ ”
When the working cycle has finished, the buzzer of the
dishwasher will sound 8 times, then stop.
Turn off the appliance using the On/Off Button.
If the appliance is switched
off during a wash cycle.
Open the do or care fully.
Look o ut for hot ste am
when openin g the d oor!
If the appliance is switched off during a wash cycle, when switched
on again, please re-select the washing cycle and operate the dishwasher
according to the original Power-on state ).
Switch on the appliance Open the door,p ress the On/Off button to switch on the appliance .
1.Open the door a little to stop the dishwasher.
2.After the spray arms stop working, you can open the door completely.
3.Add the forgotten dishes.
4.Close the door, the dishwasher will start running again after 10 seconds.
For detailed operating method read the co rresponding conte nt on the instruction manual.
1. A running cycle can only be modified if it has been running for a short time. Otherwise the detergent
may have already been released and the water already drained. If this is the case, the detergent
dispenser must be refilled.
2. Open the door.
3. Press the
for more than 3 seconds to cancel the running programme.
4. Select a new programme.
5. Restart the dishwasher.
Programme Button
5
For each wash cycle.
For programs with pre-wash,please put the detergent anywhere inside the
inner tank except in compartment A
(Follow the user instructions!)
Electric indicator on control panel (if provided).