DeDietrich DTI789V, Инструкция по установке и эксплуатации

Страница: 9 / 14

EN
21
2 / USING YOUR APPLIANCE
To reproduce the cooking cycle:
- Select the same cooking zone (if the zone is
different, NO will light up on your hob).
- Press on touchpad J , and the different mem-
orised power levels will appear in a few
moments. When the power indicator stops
flashing, the cooking starts.
N.B. :
- Every memorisation deletes the previous
one.
- Only 5 different cycles can be memorised
per cycle. If you go beyond that, NO will dis-
play on your hob.
- In order to accurately reproduce the memo-
rised cycle, we recommend that you always
use the same cookware.
- The pre-heating function is not available in
“MEMO” mode
- If your hob is off, touching the button J will
display the memorised power settings on
the corresponding display.
•Delayed cooking
This function allows you to delay your cooking
(available only for “Start Control”zone).
Program delayed cooking in 6 steps:
1 - Select the cooking zone dedicated to this
function.
2 - Press simultaneously on touchpads I “ + ”
and “ – ” to adjust the current time of your
hob. When the numbers flash, you can
adjust the hour with the touchpad
I , then
wait a few moments. If the hour displayed
is correct, wait a few moments. The display
will stop flashing and a beep will confirm
the setting.
3 - Set the end of cooking time by pressing on
touchpad I . Wait a few moments. A beep
will confirm your setting.
4 - Set the duration of cooking time by press-
ing on touchpad I . Wait a few moments. A
beep will confirm your setting.
5 - Set the power of your cooking by pressing
on touchpad G, 4 is displayed by default
(maximum 6). Wait a few moments. A beep
will confirm your setting and
SC is dis-
played on your hob.
6 - After a few moments, SC goes out and a
flashing point appears to indicate that
delayed cooking has been engaged.
•Independent timer
This function allows you to time an event,
without cooking.
- Select a cooking zone you are not using.
- Set the time with touchpad
I . A “ t ” flashes in
the display.
- At the end of your adjustment “ t ” becomes
becomes fixed and the count begins.
Note:
You can stop a count in progress by keeping
your finger on the touchpad of the selection
on the display.
A
B C
E
F
G
G G
G
H
H
H
I
I
I
K
J
M N
N
99642302_A_ML.qxp 04/10/2007 10:01 Page 21