4
•
1
INSTALLATION
The oven must be connected via a
standardised power cable with 3
conductors of 1 mm² (1 live + 1 n
earth) which must be connected to the
network by means of an IEC 60083
standard power socket or via an all-pole
cut-off device in compliance with the
installation rules.
Check that:
- the electrical installation has sufficient
voltage (220-240 Volts~ 16 Amps).
If the electrical installation in your home
requires any changes in order to
connect your appliance, contact a
professional electrician.
During maintenance operations, the
appliance must be unplugged from the
electrical grid; fuses must be switched
off or removed.
Warning:
The safety wire (green-yellow) is
connected to the appliance’s
terminal and must be connected to
the installation’s earth.
If the oven malfunctions in any way,
unplug it or remove the fuse for the
circuit where the oven is installed.
Warning:
We cannot accept liability for any
accident or incident resulting from
non-existent, defective or incorrect
grounding.
CHOICE OF LOCATION AND
BUILDING IN
This appliance must be installed more
than 850 mm up off the ground. This
appliance may be installed in a cabinet
column, as indicated on the installation
diagram
(fig. A)
.
Caution: if the back of the cabinet is
open, the space between the wall and
the surface on which the oven rests
must be no more than 70 mm*
(fig. B)
.
Do not use your appliance immediately
(wait for about 1 to 2 hours) after
transferring it from a cold place to a
warm place, as condensation may
cause a malfunction.
Centre the oven in the cabinet so as to
ensure a minimum distance of 10 mm
between the appliance and the
surrounding unit. The material of the
cabinet supporting the appliance must
be heat resistant (or covered with a
heat-resistant material).
Drill a 2 mm diameter hole in the cabinet
panel to avoid splitting the wood.
For greater stability, attach the oven to
the unit with 2 screws through the holes
provided on the side panels
(fig. C)
.
ELECTRICAL CONNECTION
Warning
:
Installation should only be
performed by installers and qualified
technicians.
The appliance must be recess-fitted
correctly to ensure electrical safety. The
electrical connections should be made
before the appliance is installed in its
housing.
