9
EN
x 4
x 16
approx.
350 mm
x 1
x 1
x 4
x 8
x 2
560 + 1 mm
Position the appliance on the rails, making sure the pins are
correctly inserted in the housings, then fix it with the screws
supplied.
If the height of the appliance requires adjusting, use the spacer
disks provided.
x 4
x 16
approx.
350 mm
x 1
x 1
x 4
x 8
x 2
560 + 1 mm
If necessary, correct alignment of the appliance by positioning
the spacers supplied under or at the sides of the support.
USING THE APPLIANCE FOR THE FIRST TIME
• Coffee has been used to factory test the appliance and it is
therefore completely normal for there to be traces of coffee
in the mill.
• Customise water hardness as soon as possible following
the instructions in the “Water hardness” section.
1. Connect the appliance to the mains electricity supply and
place the main switch (A23) in position I.
2. The appliance displays “FILL TANK” in different languages.
Extract the water tank (fig. 4), rinse and fill with fresh water
without exceeding the MAX line. Replace and push as far as
it will go.
3. Choose the language (the languages scroll through at in-
tervals of about 3 seconds):
When the message “PRESS OK TO SET TO ENGLISH” is dis-
played, press the icon (B4) (fig. 3) for 3 seconds until
“ENGLISH SET” is displayed. If you set the wrong language,
follow the instructions in the “Setting the language” sec-
tion.
If your language is not available, select one from those dis-
played (the instructions refer to English).
Then follow the instructions displayed:
4. Place a cup under the hot water spout (fig. 5).
(If the hot water spout is not inserted, the appliance dis-
plays “INSERT WATER SPOUT”. Attach the spout as shown
in figure 6. The machine displays “HOT WATER PRESS OK”.
Press the icon (B4), a little water comes out of the
spout.
5. After that the machine displays “TURNING OFF PLEASE
WAIT” and goes off.
6. Extract the appliance by pulling it out using the handles
(fig. 7).
Open the lid and fill the container with coffee beans, then
close the lid and push the appliance in.
The coffee machine is now ready for normal use.
Important!
Never introduce pre-ground coffee,
freeze dried coffee, caramelised beans or anything else which
could damage the appliance.
Please note:
When using the appliance for the first
time, you need to make 4-5 cups of coffee and 4-5 cappuccinos
before the appliance gives satisfactory results.
Please note:
Each time you turn the coffee machine
on by the main switch (A23), it performs an AUTO DIAGNOSTICS
cycle and then goes off.
To turn it on again, press the ON/stand-by button (A7) (fig. 1)
TURNING ON AND HEATING UP
Each time the appliance is turned on, it performs an automatic
preheat and rinse cycle which cannot be interrupted.
The appliance is ready for use only after completion of this cycle.
Danger of burns!
During rinsing, a little hot water
flows from the coffee spouts.
To turn the appliance on, press the ON/stand-by button (A7) (fig.
1). The message “HEATING UP PLEASE WAIT” is displayed.
When heating is complete, the message changes to “RINSING”.
The appliance is at temperature when the message “COFFEE
STANDARD” is displayed.
Содержание DKD7400X
Страница 2: ......