Instructions for Use
15
methods except for those recommended by the
manufacturer.
x
Warning!
When installing, cleaning, or removing
the appliance, make sure the insulation on the
refrigeration system parts is not damaged. Thus
you will also prevent damage to the environment.
x
Warning!
Do not use electric appliances in the
refrigerator or freezer interior, except for those
expressly allowed by the refrigerator-freezer
manufacturer.
x
After the installation, the appliance mains plug
should be accessible!
The symbol on the product or on its
packaging indicates that this product
may not be treated as household waste.
Instead it shall be handed over to the
applicable collection point for the recycling of
electrical and electronic equipment. By
ensuring this product is disposed of correctly,
you will help prevent potential negative
consequences for the environment and human
health, which could otherwise be caused by
inappropriate waste handling of thisproduct.
For more detailed information about recycling
of this product, please contact your local city
office, your household waste disposal service
or the shop where you purchased the product.
Storing time during power supply interruption
Avoid opening the freezer in case of failure or
power supply interruption unless the interruption is
extended over longer period of time (15 hours).
Disposing of the worn out appliance
x
When your appliance finally wears out, dispose
of it. If the appliance has a lock, break it to
prevent any accidents (danger of children getting
locked inside the appliance).
x
The refrigeration system of the appliance is filled
with refrigerant and insulating substances which
should be treated and processed separately. Call
your nearest authorised service agent or
specialised servicing centre. If you cannot find
one, contact your local authorities or your
distributor. Be careful not to damage the tubes
on the rear wall of the appliance (danger of
pollution).
x
To avoid pollution of the environment make sure
not to damage the hose at the bottom of the
appliance.
Placing and installation
Choosing the right place
Place the appliance in a dry and well ventilated
room. Allowed ambient temperature depends on
the model (class) of the appliance and it is stated
on the rating plate of the appliance. Never place
the appliance near heat emitting devices (e.g.
cooker, radiator, water heater and similar devices)
and do not expose it to direct sunlight.
The appliance should be positioned at least 3 cm
away from the electric or gas cooker and at least
30 cm away from the oil or coal stove. If this is not
possible, use appropriate insulation.
Class
Ambient temperature
SN (sub-normal)
from + 10°C to + 32°C
N (normal)
from + 16°C to + 32°C
ST (sub-tropical)
from + 16°C to + 38°C
T (tropical)
from + 16°C to + 43°C
Connection to Power Supply
Use the cable and plug to connect the appliance to
the power supply socket outlet with a ground
terminal (safety socket).
Required nominal voltage and frequency are
indicated on the rating plate.
The connections to the mains supply and earthing
have to be made according to relevant standards
and regulations. The appliance resists temporary
voltage fluctuations of up to +/- 6 %.
Adjusting the height of the appliance
The appliance is equipped with four adjustable
legs which allow adjusting the height in the range
from 82 to 90 cm. The height must be adjusted
prior to building the appliance into the opening slot,
and it should be set at such height that the top
panel of the appliance fits exactly below the
kitchen worktop (see
Mounting instructions
).
