DeCrane Aerospace Audio International
MCD-9101-101-x Installation & Operation Manual
Document # 540360, Rev IR, 03/2008
Page 8 of 28
3.2
Unpacking and Inspection
3.2.1 Carefully open the packaging and remove the MCD-9101-101-x.
Verify that all components have been included in the package per
the packing list. Inspect the unit for shipping damage.
3.2.2 If damage has occurred during shipping, a claim should be filed
with DeCrane Aerospace Audio International WITHIN 24 hours and
a
Return Request Authorization Number
shall be obtained from
DeCrane Aerospace Audio International by contacting the Repair
Department at 501.801.8101. Repackage the unit in its original
packaging materials and return it to DeCrane Aerospace Audio
International following instructions given by the DeCrane
Aerospace Audio International representative. Refer to the front
cover of this manual for address. If no return is necessary, retain
the packing list and the packing materials for storage.
3.3
Cautions & Warnings
3.3.1 It is important to do a pin-to-pin power and ground check on all
connectors. Ensure that power and ground are applied only where
specified. Damage to the unit may result if power or ground is
applied to the wrong points.
3.3.2
DO NOT
connect or disconnect the unit while power is applied.
3.3.3
DO NOT
remove any factory-installed screws. Damage to the unit
may result and void any warranties.
3.3.4
DO NOT
drop the unit or subject it to strong shock. The unit
contains glass parts that may break or crack.
3.3.5
DO NOT
use commercially available CD accessories that can be
loaded into the CD slot (stabilizers, protective sheets, CD cleaning
discs, etc.). They can cause the unit to malfunction.
3.3.6
DO NOT
use dirty CDs or CDs colored on the data side. If you try
to play CDs that are colored on the recorded side (opposite the
label), or CDs that are dirty, they may fail to slide in or out. Also, do
not put tape on CDs and attempt to insert into the unit. This could
cause failure or damage to the unit.
