OPERATING INSTRUCTIONS
CONTROL PANEL OPERATING PROCEDURES
Control panel on the front unit
Flip down the front grill panel to reveal control panel
1
．
1
.
A
d
j
u
s
t
1. Adjustable Thermostat
2
．
On/Off Heater button
3
．
On/Off Main power button
4
．
Adjustable Flame Brightness
Flame Operation:
1. To turn on the Flame Effect of your fireplace, push the power button .
.
2.
To adjust the Flame Effect, turn the brightness Knob until it reaches your desired brightness.
3.
To turn off the Flame Effect, push the power button again.
Thermostat Instructions (LOW, MED & HIGH)
1. Allow the Heater to warm up the room before setting the thermostat.
2. When the desired temperature is reached, lower the thermostat until the unit shuts off. This is done by turning the
Thermostat Knob towards (LOW)
3. The heater will now automatically maintain the set temperature by cycling on and off.
4. To adjust the thermostat, turn the thermostat knobs towards (HIGH) to increase the desired temperature and towards
(LOW) to decrease the desired temperature.
5. NOTE: It is normal for the Heater to cycle ON and OFF as it maintains the desired temperature.
ELECTRICAL CONNECTION
A 15 AMP,120 Volts,60 Hz circuit with a properly grounded outlet is required. It’s recommended that the fireplace will
be on a dedicated circuit as other appliances on the same circuit may cause the circuit breaker to trip or blow the fuse to
blow when the heater is in operation.
ELECTRICAL SPECIFICATIONS
Voltage:
120VAC, 60 Hz
Amps:
12.5Amps
Watts:
1500 Watts
Lighting:
LED
