3
•
Risk of Indoor Air Pollution – Use the unvented decorative fireplace only in a well-ventilated area and
with doors of adjacent rooms open. Do not obstruct air flow to the fuel holder box by piling logs over
the fuel reservoir or in any other way with any other material. People with breathing problems should
consult a physician before using the unvented decorative fireplace.
•
The following or equivalent information for provision of combustion and ventilating air for unvented
decorative devices: ''In a house of typical construction, that is, one that is not of unusually tight
construction due to heavy insulation and tight seals against air infiltration, an adequate supply of air
for combustion and ventilation is provided through infiltration.” The unvented decorative appliance
should not be used in a small room where less than 5.7 m
3
(200 ft
3
)
of air space is provided for each
1000 Btu per hour of the unvented decorative device rating (considering the maximum burner
adjustment). Do not use the unvented decorative fireplace in a bathroom, a room where sleeping
accommodation is provided or any other small room.
•
Make sure that the shut off device works properly before lighting.
NOTE: I have removed the paragraph that was placed in between Do not use …. And Risk of Indoor Air
Pollution…. ; it was a duplication of a paragraph on page 2.
INSTALLATION OF THE WALL MOUNTED FIREPLACE AND BURNER
•
Model
CITY 106A
is wall-mounted.
•
A horizontal support and two vertical supports are provided with the fireplace.
•
Determine the location of your fireplace. It must be located at a minimum of 12’’ above the floor, at a
minimum of 24’’ from the ceiling, and allow a clear distance of 12’’from the right and left edge of the
unit.
•
To attach the hanging support, refer to the drawing for installation
.
•
Locate 2 wall studs (obligatory), that are at 16’’ center to center.
•
Attach the horizontal support (no 1) using a bubble level tool with 2 no.12 x 1 ½’’ wood screws (no.4).
•
Hang the 2 vertical straps (no.2) on the hooks of the horizontal support (no.1) and ensure that they are
square. Add brackets (no. 3) into the first rectangular hole at the bottom of each of the vertical straps,
attach them with 4 no. 12 x 1 ½’’ wood screws (no.4). You will need two people to move the fireplace
(no.5) into position, place it onto the hooks of the horizontal support (no.1) by matching up the hooks
with the square holes at the back of the unit.
•
Make sure that the fireplace is level.
•
Attach the 2 vertical supports (no.3) at the base of the fireplace (no.5) with 2 self-tapping screws
(no.6).
•
Place the burner support (no.7) into the fireplace opening.
•
Insert the reservoir (no.8) into the burner support (no.7).
•
Place the damper (no.9) onto the top of the bio-ethanol reservoir (no.8).
•
Using the designated holes install the window panes (no. 10) onto the front of the fireplace. Ensure
that they open and close correctly.
