STEP 1
Place frame on DECKED system. Determine
if your slide frame’s cross brace (the steel
strap mid-frame) mounting holes align
with the locations of the steel tubes in the
DECKED system. (The location of the steel
tubes in the deck halves are indicated by a
series of dimples).
STEP 2
If these holes do not align precisely on center
with the DECKED steel tube you will need to
either re-drill your slide frame’s cross braces
or weld on another cross brace. Use same
thickness steel as manufacturer’s (shown is
¼” thick x 2” wide). We spray-painted this
for rust prevention.
HARDWARE NEEDED:
·
4
—
2” x 5/16” #18 bolts
— McMaster.com part #91247A591
·
8
—
5/16” sealing washers
— McMaster.com part #94708A413
·
4
—
Thin hex nuts
— McMaster.com part #91847A030
·
12
—
5/16” washers
DECKED | 1
NOTE: Make
sure to use
bolts (rod
plus thread)
NOT screws
(thread only).
CAUTION
: Ignoring the sealing washers
could lead to water intrusion. If you plan on
using a tonneau or cap over the slide install,
you can omit using the sealing washers as
there won’t be a water risk.
