Decatur Electronics GHD, Руководство пользователя

Страница: 11 / 41

GHD
TM
& SCOUT
TM
USER’S MANUAL
9
Once the batteries have been properly loaded into the holder and the
holder has been inserted into the handle of the gun then the door can
be put back in place and slid closed. If you have not already charged
the batteries using an optional NiMH charger, you are now ready to
charge the batteries using the power cable.
If the holder has been placed incorrectly into the handle the door
can not be put back in place and closed.
3.6 Charging the Batteries - SCOUT
The power cable that comes with the SCOUT can be used to
either power the SCOUT directly from your vehicle receptacle
or to charge the SCOUT’s batteries. Once the batteries have been
properly installed into the holder and inserted into the handle plug
the power cord into the power connector at the base of the handle
by aligning the red dot on the power cord’s plug with the red dot on
the connector. Failure to align the plug with the connector properly
will result in damage to the pins of the jack. Reference figure 3.6 for
proper alignment.
Figure 3.6
Next, plug the lighter plug into an active cigarette lighter receptacle
in the vehicle. The red led on the lighter plug should come on
showing that power is being applied to the SCOUT. With the SCOUT
turned off, it will take approximately 2 hours to fully charge the
batteries. Turning the SCOUT on with the cord plugged in will stop
the charge cycle allowing the gun to be operated from the power
cord. Batteries do not charge when the gun is turned on.