Please read all sections of this manual and retain for future reference.
Installation, maintenance, and repairs should be performed by your Dean Factory
Authorized Service Agency.
WARNING!
SAFE AND SATISFACTORY OPERATION OF YOUR EQUIPMENT DEPENDS ON
ITS PROPER INSTALLATION. INSTALLATION MUST CONFORM TO LOCAL
CODES, OR IN THE ABSENCE OF LOCAL CODES, WITH THE U.S. NATIONAL
ELECTRIC CODE, NFPA 70-1984 (OR LATEST EDITIONS) OR APPROPRIATE
EUROPEAN COMMUNITY/NATIONAL CODES/STANDARDS.
WARNING!
ELECTRICAL GROUNDING INSTRUCTIONS
THIS FILTER IS EQUIPPED WITH A THREE-PRONG, GROUNDED PLUG FOR
YOUR PROTECTION AGAINST SHOCK HAZARD AND SHOULD BE PLUGGED
DIRECTLY INTO A PROPERLY GROUNDED, THREE-HOLE RECEPTACLE. DO
NOT CUT OFF, REMOVE OR OTHERWISE BYPASS THE GROUNDING PRONG
ON THIS PLUG.
IF IT IS NECESSARY TO USE AN EXTENSION CORD, IT MUST BE A THREE-
CONDUCTOR, GROUNDED CORD OF 16 GAUGE OR GREATER.
CAUTION
DO NOT FILTER MORE THAN ONE FRY TANK AT A TIME.
HOT FLUID – DO NOT FILL BEYOND MAXIMUM FILL LINE
LOCATED ON THE OIL CONTAINER.
CAUTION
THIS FILTER UNIT IS NOT SUITABLE FOR OUTDOOR USE.
WHEN OPERATING THIS UNIT, IT MUST BE PLACED ON A
HORIZONTAL SURFACE.
CAUTION
THIS FILTER UNIT IS NOT SUITABLE FOR INSTALLATION IN AN
AREA WHERE A WATER JET COULD BE USED, AND THAT THIS
APPLIANCE MUST NOT BE CLEANED BY A WATER JET.
IF THIS FILTER UNIT IS CLEANED WITH WATER, DISCONNECT
THE UNIT FROM POWER SOURCE BEFORE CLEANING AND
THOROUGHLY DRY THE FILTER UNIT BEFORE
RECONNECTING TO ELECTRICAL POWER SOURCE.
