CP100 BACK PANEL
EFX F.S. (FOOTSWITCH):
This jack is for connection to a shorting footswitch. When the switch is closed, the on board digital EFX
will be bypassed.
EFX SEND:
This jack provides an unbalanced output signal from the
CHANNEL-2
preamp for supplying signals to external low-level
effects or signal processing equipment. This signal is “pre” tone controls. (The tone controls will not affect the EFX SEND signal)
EFX RETURN:
Input for “returning” signals from external low-level effects or signal processing equipment. This signal is pre tone
controls and EFX.
(CHANNEL-2 tone controls and on board digital EFX will affect this signal)
LINE OUT:
This jack provides an unbalanced output from the preamp that is post eq and post efx. This signal is pre MASTER
VOLUME which means that this signal will not change with the MASTER VOLUME setting. This send can be used to feed a signal to
a recording or sound reinforcement mixer. Additionally this output can be used to drive a slave amp or powered extension speaker.
DIRECT OUT:
Balanced output signal used to feed recording or sound reinforcement equipment. This signal is post eq and post efx
but is pre MASTER VOLUME.
TAPE/CD
: Unbalanced phono (RCA) input jacks. This is an auxiliary input designed for use with a drum machine, tape player, CD
player, etc. and can be used for playing prerecorded music.
TAPE/CD LEVEL
: This “inset” control adjusts the volume level of the TAPE/CD input. This control can be adjusted with a small
screwdriver. This signal is pre MASTER control which means that the MASTER volume setting will affect the loudness of the
TAPE/CD input signal.
AC INPUT:
Connect the female end of the AC line cord here. Connect the male plug to a suitable source of line voltage. Refer to the
voltage information on the back of the amplifier for its voltage and current requirements. This connector also acts as the main fuse
holder and includes a compartment for a spare fuse.
POWER:
This rocker switch turns the AC power ON and OFF.
Digital EFX Program List
1.
Chorus:
Stereo chorus.
2.
Flange:
Stereo flanger for jet wash effects
3.
Plate 2:
Sizzling bright plate reverb.
4.
Plate 3:
Short vintage plate reverb.
5.
Room 3
: Warm room reverb.
6.
Plate 1:
Classic plate reverb.
7.
Bypass:
No Effect
8.
Rotary Speaker:
Rotary speaker emulation
9.
Chorus/Room 1:
Chorus with reverb.
10.
Chorus/Room 2:
Auto-wah effect with reverb.
11.
Delay 1:
125ms slapback delay
12.
Delay 2:
190ms delay for percussive arpeggios
13.
Hall 1:
Bright hall reverb.
14.
Hall 2:
Warm hall reverb.
15.
Room 1:
Hardwood studio reverb.
16.
Room 2:
Ambience for acoustic mixes