INSTALLATION PROGRAM
Once the installation is over, by pressing the “OK” and “-“
buttons, the AL softener will carry out the auto-installation
program. The device will be ready to run and supply soft
water upon completion of such procedure.
The auto-installation program will rinse the resin and fill
the brine tank with the right amount of water in a few
minutes and in fully-automated mode.
RESIN RINSING PROGRAMME
It can sometimes happen that the softener supplies
salt water.
This problem is caused by lack of pressure in the
water pipes during the last regeneration cycle
preventing an adequate rinsing procedure.
Thanks to the resin rinsing program, all the salt water
in the softener can be drained in a matter of minutes.
Pres
s the “
+
” and the “
ok
” buttons so as to read the
following message in the display to start this program:
“ RESIN RINSING”
