How to use the product
7
IMPORTANT :
You MUST release the air completely out of the device before removal.
You can do so by pulling the air injection hose as shown above in Step 2.
WARNING :
Do not attempt to sit up, stand or move your head left or right when using
the Cervitrac from the supine position. You must remain in the supine position until
the Cervitrac is completely removed.
How to use the product
Place the Stand on a level floor surface.
Gently pull the Air Injection Hose to release any remaining air
from the Traction Belt. The Belt must be completely deflated
before application.
While looking straight up, place the Chin Collar on your chin
and fasten it to the Traction Belt via the Velcro attachments.
Connect the Hand Air Pump to the Air Valve precisely
attaching the Air Injection Tong with the Air Valve.
Proceed to slowly use the Hand Air Pump to inflate the Belt.
Inflate at a rate that is no faster than 1 stroke in each direction
every 5 seconds.
Start with a low pressure (5 PSI) on the first day and gradually
increase to 7 PSI on the second day and then to 9 PSI on the
third day. Recommend usage is 7~9 PSI or less depending on
your comfort.
Wear for 15-30 minutes. You can adjust the air pressure at
anytime to your comfort level by momentarily pressing the Air
Valve to release air. Release pressure to reach a comfortable PSI
level if experiencing any discomfort.
Attach the Traction Belt to the center of the Stand via Velcro.
Lie down and carefully place your neck on the center of the
Traction Belt with your legs bent at a 45
º
angle.
Supine Position
