Material No.
Page
TC-605
5/11
Terminal No.
Contact
Lance
CM10-SP10S(D6)
3-5. Inserting a contact
Insert the contact into the specified terminal number point in the housing.
(Insert grounding wire or drain wire into terminal No. 10).
* When the contact catches the housing, you will hear a snap.
* Pulling the wire for confirming the correct position.
Note! Before inserting the contact, check that the clamp nut, cable clamp, bushing and angle back
shell is inserted.
Take care not to insert the contact upside down as shown below.
* Insert the contact so that the terminal
number face the same direction.
However, in case of CM10-SP2S(D6), insert the
contact so that the lance and the terminal
number face the opposite direction.
* Using a pull out tool for pulling up inserted contact.
Tool No.: 357J-50548T
Refer to the instruction manual in case of using
pull up tool.
* As Lance falls down easily after pulling up,
set up to original position before re-insert.
Terminal No. 10 only
(Grounding wire or drain wire)
Housing
Contact
Cable
Insert
CM10-SP2S(D6)
Lance
Terminal No.
Contact
